H FRAME MEASUREMENTS WANTED - ANYBODY?

[M1163]

Does anyone have a rear canvas frame they can measure so we can fabricate one, here's what we need...... wt=?" /dt=?" /db/lt/ etc
Thanks in advance - Paul and Ras1 - Ohh forgot the height of brace to roll cage maybe down from top might be easiest.

[Rasmusrentals]

Yes, I do. I can measure it for you tomorrow.

[Rasmusrentals]

Here is what I came up with. Due to extreme ADHD it is not perfect but I hope it helps. This is from an M1161 serial # ITV110
This is the rear frame for the canvas and the front frame for the gun ring. mounts just over and in front of the rear wheels.

This is a revised drawing, changes are highlighted in yellow.

[M1163]

Thanks Perfect!

[killjoy35]

You all rock! I've been needing the same information. I've had a real hard time trying to find someone to make this and the canvas pieces. Thanks again.

Killjoy35

[Rasmusrentals]

I had 4 of these made. 2 are already spoken for, but I can sell the other 2. The only parts I didn’t have made is the bracket for the strut that helps lower the gun ring and the top center bracket that goes to the gun ring. I also have the mounting bushings.

[TJCUSMC]

Are you going to be selling these?

[Rasmusrentals]

Yes, I had 2 extra made so I can sell them. The guys made a jig so if I need more they can make them up pretty quickly.

[Oliveiron]

I'm interested.. extremely 😬